depronman
Find latest postsMini Statistics
- Join Date
- 01-11-2018
- Last Activity
- 3 Hours Ago
- Avatar
More 4 Friends
Recent Visitors
This page has had 11,524 visits
- Tab Content
- depronman's Activity
- About Me
- Friends
- Video Library
-
Older Activity
-
8 Hours AgoTo me it looks like you are going to slow with the feed rate1 replies | 71 view(s) -
1 Day AgoJazz answered your question perfectly. But I'll answer with another question. How are you going to interface the UC300eth with the servo? The thought...11 replies | 9151 view(s)
-
3 Days AgoThe UC100 is a respected device. Be aware there's a grey market out there with fake UC100s - obviously the horse has bolted here, but just go into...18 replies | 1554 view(s)
-
3 Days AgoThe copy of the manual I found online suggest pin 61 is a +12V (10mA max) regulated supply. Check that is +12V wrt the common rail (99.9% convinced...21 replies | 4819 view(s)
-
4 Days AgoIf you was to write a pot on the spindle controller, you should have 3 pins on the spindle controller to attach to, what are those? Likely a good...21 replies | 4819 view(s)
-
4 Days AgoFrom what I squinted at with that particular board the circuitry was visible separate from the LV and HV sides. You’d supply the LV from the general...21 replies | 4819 view(s)
-
4 Days AgoJohn, I've looked at the link to that board and I can't work it out - but it looks probable (PCB underside image) that the 0V reference for the 0-10V...21 replies | 4819 view(s)
-
1 Week AgoThough I'd be exploring the bullet on the S 720 feature list...18 replies | 1554 view(s)
-
1 Week Ago303 Euros?? I'd concur with the earlier recommendations of the UCxx hardware.18 replies | 1554 view(s)
-
1 Week AgoI think Jazzcnc also stocks controllers in the UK. https://www.jazzcnc.co.uk/motion-control18 replies | 1554 view(s)
-
1 Week AgoCertainly can be made to work, however, bear in mind the switching time for the relay(s) - guessing in the order of 5-10ms (I'll let you do the math...21 replies | 4819 view(s)
-
1 Week AgoWithout data sheet (I've googled for 5 minutes and given up to watch the F1 qualifying instead) - and without knowing the sensor supply voltage...21 replies | 4819 view(s)
-
2 Weeks AgoHave you checked for a broken connection at the spindle or somewhere along the cable where it gets a lot of flex4 replies | 735 view(s)
About depronman
Basic Information
About depronman
- City:
- St Annes on the Sea
- Country:
- United Kingdom
Statistics
Total Posts
- Total Posts
- 159
- Posts Per Day
- 0.12
- Last Post
- Denford cyclone conversion 21-05-2022
Total Thanks
- Total Thanks
- 6
General Information
- Last Activity
- 3 Hours Ago
- Join Date
- 01-11-2018
- Referrals
- 0
conect 121 / cadet lathe...