- Tab Content
- Bopper1968's Activity
- About Me
- Friends
- Video Library
- Tab Content
-
Older Activity
-
1 Day AgoWell, you are in a funny place with this machine and heading on a potentially slippery slope.? There is no easy way to say this so I'll just say it.!...2 replies | 190 view(s)
-
3 Days AgoJust use the widest cutter you have and write a bit of code to make test cuts for both directions on a piece of scrap then adjust as required,...1 replies | 248 view(s)
-
4 Days AgoJAZZCNC replied to a thread How to setup Chinese AASD Servo electronic gearing in Machine DiscussionDazp suggests a good board because the UB1 is an excellent choice if you are using servos due to the fact its differential line drivers are nice and...12 replies | 9395 view(s)
-
4 Days AgoOK, but how do you expect us to give you meaningful help if you are showing pics that don't match how you have it set up.? My suggestion is that...5 replies | 365 view(s)
-
5 Days AgoJAZZCNC replied to a thread How to setup Chinese AASD Servo electronic gearing in Machine DiscussionThe 400Khz is per axis output.12 replies | 9395 view(s)
-
5 Days AgoProbably because you are using the wrong Port.? Port #1 which you are using is mostly Inputs, Port #2 and #3 are the ones with all the outputs on...5 replies | 365 view(s)
-
5 Days AgoYour welcome, This offer also goes to anyone else who is lurking in the background and thinking about getting into CNC but is unsure of what's...3 replies | 440 view(s)
-
6 Days AgoOk, That's a shame and it will most likely perform ok, but that doesn't mean it's a good choice.! Also, let me just point out that it's a common...18 replies | 1703 view(s)
-
1 Week AgoMach3 is a bad choice, it's unsupported and does have some bugs which won't ever get fixed. UCCNC is far better software that is supported and made...18 replies | 1703 view(s)
-
1 Week AgoHello, iestyn, If you want to take a trip across to Goole you are very welcome to come to visit our Workshop and I will give you a crash course...3 replies | 440 view(s)
-
3 Weeks AgoJAZZCNC replied to a thread ATC spindle pushes toolholder when the drawbar is released in Machine DiscussionNot a dumb question but not how it works. The Drawbar clamp which grabs the pull stud is pulled against a taper machined into the spindle shaft...3 replies | 895 view(s)
-
3 Weeks AgoJAZZCNC replied to a thread ATC spindle pushes toolholder when the drawbar is released in Machine Discussion#1 Very likely be you have the wrong pull stud or the wrong holders. BT30 and ISO30 look the same but they are very slightly different. #2 Yes you...3 replies | 895 view(s)
About Bopper1968
Basic Information
About Bopper1968
- City:
- Bathgate
- Country:
- United Kingdom
Statistics
Total Posts
- Total Posts
- 6
- Posts Per Day
- 0.01
- Last Post
- CNC Router Servicing 27-07-2021
Total Thanks
- Total Thanks
- 1
General Information
- Last Activity
- 29-07-2021
- Join Date
- 20-10-2019
- Referrals
- 0
Small machine to cut mild steel