. .
Tab Content
  • JAZZCNC's Avatar
    31 Minutes Ago
    I have built several machines just like this which lift the whole gantry up, the gantry is effectively the Z axis, and they are very ridged at all...
    3 replies | 328 view(s)
  • JAZZCNC's Avatar
    4 Weeks Ago
    JAZZCNC replied to a thread Help Mach3 in General Discussion
    Check the wiring, check the pin numbers, check the cable, and after this then difficult to say without being in front of the machine. Personally, I...
    57 replies | 12366 view(s)
  • JAZZCNC's Avatar
    4 Weeks Ago
    JAZZCNC replied to a thread Help Mach3 in General Discussion
    Ah didn't realize you were using the parallel port. Well in that case then if it does it with both boards and you are sure the pin number is correct...
    57 replies | 12366 view(s)
  • JAZZCNC's Avatar
    4 Weeks Ago
    JAZZCNC replied to a thread Help Mach3 in General Discussion
    If you are absolutely sure you have the correct pin numbers for the Dir pin and when you replace the wiring and it still doesn't work then yes it's a...
    57 replies | 12366 view(s)
No More Results
About JAZZCNC

Basic Information

About JAZZCNC
City:
wakefield
Country:
United Kingdom

Signature


-use common sense, if you lack it, there is no software to help that.

Email: dean@jazzcnc.co.uk

Web site: www.jazzcnc.co.uk

Statistics


Total Posts
Total Posts
8,434
Posts Per Day
2.11
Last Post
Moving gantry Z axis 31 Minutes Ago
Total Thanks
Total Thanks
108
General Information
Last Activity
19 Minutes Ago
Current Activity
Viewing Attachment
Join Date
26-08-2011
Referrals
1

28 Friends

Showing Friends 1 to 10 of 28
Page 1 of 3 123 LastLast