. .
Tab Content
  • JAZZCNC's Avatar
    13 Hours Ago
    I have built several machines just like this which lift the whole gantry up, the gantry is effectively the Z axis, and they are very ridged at all...
    4 replies | 387 view(s)
  • JAZZCNC's Avatar
    4 Weeks Ago
    JAZZCNC replied to a thread Help Mach3 in General Discussion
    Check the wiring, check the pin numbers, check the cable, and after this then difficult to say without being in front of the machine. Personally, I...
    57 replies | 12397 view(s)
  • JAZZCNC's Avatar
    4 Weeks Ago
    JAZZCNC replied to a thread Help Mach3 in General Discussion
    Ah didn't realize you were using the parallel port. Well in that case then if it does it with both boards and you are sure the pin number is correct...
    57 replies | 12397 view(s)
  • JAZZCNC's Avatar
    4 Weeks Ago
    JAZZCNC replied to a thread Help Mach3 in General Discussion
    If you are absolutely sure you have the correct pin numbers for the Dir pin and when you replace the wiring and it still doesn't work then yes it's a...
    57 replies | 12397 view(s)
No More Results
About dudz

Basic Information

Age
53
About dudz
City:
Dunedin
Country:
New Zealand
Interests:
Building. Motorcycles.
Occupation:
Electrician

Signature


3 axis CNC/router / Alu profile frame....25mm Alu Cutting bed X=500mm Y=300mm Z=110mm.....Supported 25mm X rails ....Supported 20mm Y rails....Supported 20mm Z rails.....2.2kw Chinese WC spindle..... CSLAB CSMIO/IP-M 4-axis Ethernet Motion Controller....M542 Drivers..SY60STH86-3008BF Motors...running....Mach3 / Cambam / Emachineshop.

Contact


This Page
http://www.mycncuk.com/members/9406-dudz?s=80fda4a9339c30a266bfa5440389e209
Instant Messaging

Send an Instant Message to dudz Using...

Statistics


Total Posts
Total Posts
273
Posts Per Day
0.08
Last Post
Back after a few years ... Mach3 Question please 18-04-2022
Albums
Total Albums
1
Total Photos
5
Total Thanks
Total Thanks
69
General Information
Last Activity
21-04-2022
Join Date
17-10-2012
Referrals
0

2 Friends

Showing Friends 1 to 2 of 2