Originally Posted by
irving2008
1. I suppose its possible it might need changing, but a 3:1 ratio means 180rpm on the rotor and thats more than enough, can even use smaller/fewer magnets as torque requirement reduced by same ratio.
2. Not sure what you mean by torque ripple in this context, its an artifact of a motor due to bad pole design aka cogging...
3. Maybe, but plastic gears shouldn't be that noisy at these low speeds...
Epicyclic is elegant solution to problem. Belt drive would need to find a way to route belt past magnetic pole piece each end of magnet carrier, or carrier would need to be vertical or at least at an angle making use of the U-channel mounting more difficult and making the mounting of the loadcell more complex. Also belt drive might increase the footprint.