VR milling 2.31 is it good or is it best to go for Mach 3

Hi Guys,

I have a lovely little Denford Triac VMC with atc. I think I should have VR milling software version 2.31 but am thinking of trying to get the machine to a point where it could use Mach 3.
My question to anybody that knows about such matters is is the upgrade to Mach 3 worth a lot of time hassle and money? If so some pointers as to why may help me make the right decision.

Further info

If anyone knows how to upgrade my machine or has done so using off the shelf or custom parts any help would be great. I would pay for the right help and am on the south coast if there is someone local that would like a project to help with.

I have little knowledge but believe the Mach 3 need more I/O ports to interface correctly

Many thanks for any help that anyone can offer.

Best regards

sue

sue,

Have you seen this thread ?

http://www.mycncuk.com/forums/mill-b...onversion.html

Yes Eddy thank you very much but had read this one. I had better not strip mine down in my bedroom or I would be for the high jump!

Many thanks

sue