surely it would be easier to make a custom parallel cable to correct the pinouts rather than rewrite the code?
Printable View
surely it would be easier to make a custom parallel cable to correct the pinouts rather than rewrite the code?
Hello to everybody.
I have one problem with my USB to PARALLEL Port DIY Interface. It's recognized correct on PC with Win XP but when I connect it to my laptop with Win 7/32 device has not recognized (Unknow device) as well as I connect it to my desktop PC with Win 7/64. Any sugestions?
hello. can ı use thıs project with match3
Hello Sir.
sir im having trouble, which program do i need to use to control the leds? I have 8 LEDS in my project. I know how to control them using 8 PINS of the Parallel port and also using the Assembly language to create sequence of each LEDS/PINS., but what i want is, i want to control them using USB. Is this module that you have created can possibly control the LEDs?
I need your help sir. :(
Thanks a lot...
GodBless.
Where can i download this beta from this thread?
http://www.mycncuk.com/forums/showth...ull=1#post1797
The link of the download is dead.
Thanks for the help.
I did not see any connection of 5V and ground connection into the pcb design..
But in the schematic there is 5V and ground connection,
Any one please help me...
Hi
I need to convert this parallel board to USB but the firmware codes aren't suitable for it. Each pin of the parallel port goes through a Fet directly to the a coil of a motor. It controls 2 unipolar stepper motors. As you say if one needs a diferent firmware you could change it and post it here, I kindly ask you to do so.I attach the board for your reference . Thanks
Attachment 8452
hello good interface such a query to format or convert to gcode ga
I use vcarve 6.0 and then convert it from the software but it is frozen or has a special software to convert your answer gcode grasias por peru greetings
you can customize for Mach3?:nonchalance: