Attachment 20088Attachment 20089
Added T6 20mm plate:)
Printable View
Attachment 20088Attachment 20089
Added T6 20mm plate:)
I can't explain, I should probably shut up, it just looks unfinished. If the router moved back towards the gantry it would look better. If the lower Z axis bearings were at the bottom of the gantry it would look better. If the bed bearings were under the gantry so it didn't depend on verticals screwed to horizontals I would be rubbing my hands together in glee and shouting whoopy do! :very_drunk:
Robin do appreciate your comments, so far I managed to skim 10mm by putting spindle closer to the plate.
Problem is that I should ask first and fabricate later. I am seating on it now - previous correction was easier to do.
I will put X axis bearing on top and bottom of the gantry - saving a lot of distance but sacrifice stiffens (extra 50mm taller legs)
Regard the bed bearings as you see from current design they are in between spindle center point - so perfect position (this will moved towards gantry later).
Attachment 20090Attachment 20091
now Z rails left - this will complicate fabrication, thinking now to use alloy plate and make kind of box design
some modification made to design - thanks Rob
Attachment 20162Attachment 20163Attachment 20164Attachment 20165Attachment 20166in:)
Attachment 20167Attachment 20168Attachment 20169Attachment 20170
I managed to short less than 50mm in overhang - hope will be worth it.