Denford TRIAC VMC Z axis glitching.
Hi All,
I have finally got the above mill running retrofitted a CS labs motion controller with help from another forum user (Chaz). then discovered the servo drive was faulty on the Z axis I have had that repaired but now I get the occasional glitching where the z servo will just start glitching up and down eventually sending the drive unit into a fault. has anyone else experienced this or does anyone know what the problem could be.
regards
Ade
Re: Denford TRIAC VMC Z axis glitching.
is shield of encoder cable connected at drive connector?
is it red cap motor?
what drives are your triac using?
Re: Denford TRIAC VMC Z axis glitching.
Quote:
Originally Posted by
battwell
is shield of encoder cable connected at drive connector?
is it red cap motor?
what drives are your triac using?
The original Baldor setup if I remember correctly.
My Triac also did this on the X axis, but not often, I suspects it was noise but never got it sorted as it was rare to happen.