Can I retap a 1/2" 24tpi UNF female thread -> M12?
I need to mount a 13mm drill chuck onto a stepper motor shaft (don't ask!)
It seems most 13mm drill chucks come with a 1/2" female thread. Therefore I need a stepper motor shaft (M8) to 'drill chuck' thread widget/adapter ....obviously no such beast exists.
Now then, I could lay out for a 1/2" 24tpi UNF die ...but this is a one off that I'll never use again...so that not very cost effective. Therefore I was wondering ...would it be do-able to just re-tap the drill chuck's existing female 1/2" 24tpi UNF thread...to be an M12? (because I already have metric taps/dies)
Or will this be problematic?! (one issue jumps out, is that 12mm is slightly smaller than 1/2")
(btw the end result - if I get there - will be under light load)
Re: Can I retap a 1/2" 24tpi UNF female thread -> M12?
Why not buy (or borrow) a 1/2" UNF bolt, cut the head off then drill it out to suit your stepper then put in a couple of grub screws in to hold it place.
JD!
Re: Can I retap a 1/2" 24tpi UNF female thread -> M12?
Thinking about it, leave the head on then you can screw the chuck up to it and also put the grub screws through the flats on the head.
Re: Can I retap a 1/2" 24tpi UNF female thread -> M12?
Quote:
Originally Posted by
HiltonSteve
Why not buy (or borrow) a 1/2" UNF bolt, cut the head off then drill it out to suit your stepper then put in a couple of grub screws in to hold it place.
JD!
Super idea.... I guess some folks know how to go about this the right way & some folks don't (I'll be in the latter camp - so thank heavens for forums like this!)
(BTW: For once, I already have some suitable 1/2" 24tpi bolts!)
Re: Can I retap a 1/2" 24tpi UNF female thread -> M12?
Are you sure it's 1/2" x 24 ?
Most chucks I have seen are 1/2" x 20 UNF
BTW Steve if you 'borrow' a bolt what happens when the guy wants it back and you have gronched it up ? :question::question:
.
Re: Can I retap a 1/2" 24tpi UNF female thread -> M12?
I was basing the "borrow" coment on what people say to me when they want to "borrow" something, nine times out of ten I never see it again....!
Re: Can I retap a 1/2" 24tpi UNF female thread -> M12?
Quote:
Originally Posted by
John S
Are you sure it's 1/2" x 24 ?
Most chucks I have seen are 1/2" x 20 UNF
BTW Steve if you 'borrow' a bolt what happens when the guy wants it back and you have gronched it up ? :question::question:
.
It's great to nestle in the bosom of those that know.
I went and checked what I'd bought, transpires I bought a 10mm chuck (not a 13mm chuck)
http://cgi.ebay.co.uk/ws/eBayISAPI.d...lenotsupported
"3/8" x 24 thread."
Fortunately, the bolts I have were specifically bought for it at the time (a failed idea that I had, that I can now re-use these bolts for)