-
Optimum BF20L Conversion
Not quite a build log as I'm almost there but still a bit to do ;)
Lots of bits and a vague idea of what I'm actually doing
http://rikk.smugmug.com/Scale-4x4/Ma.../IMG1006-S.jpg
All mounted on a board ready for testing
http://rikk.smugmug.com/Scale-4x4/Ma.../IMG1010-S.jpg
After a few...ok quite a lot of false starts, some head scratching and some help from Hood on the mach3 support forum.....it's alive...ALIVE
http://rikk.smugmug.com/Scale-4x4/Ma.../MVI1013-S.jpg
The idea is to get everything mounted up, then redo all the mounts again properly once it's working.
X axis springs to life.
http://rikk.smugmug.com/Scale-4x4/Ma.../MVI1014-S.jpg
Y axis in, lets cut something....errr NO...get the pen out ;)
http://rikk.smugmug.com/Scale-4x4/Ma.../MVI1015-S.jpg
Hmmm, not much room...where to put the electronics? In the cupboard :) My bench goes all along the wall in front of the cupboard door, with a slide out section so I can get to the cupboard when needed. Yes it still needs tidying ;p
http://rikk.smugmug.com/Scale-4x4/Ma.../IMG1018-S.jpg
Screen on the cupboard door with a "modified" tilt/turn/swivel mount
http://rikk.smugmug.com/Scale-4x4/Ma.../IMG1017-S.jpg
Ahhh, all neat and tidy (yes it is ;p ) with some very makeshift swarf guards over the steppers, when the new mounts are made they will be boxed in with ali sheet.
http://rikk.smugmug.com/Scale-4x4/Ma.../IMG1016-S.jpg
Z mount all designed and ready to cut, but lets try it with the pen first...me nervous...NAH ;) Couple of false starts on how to zero, but Hood came through again.
http://rikk.smugmug.com/Scale-4x4/Ma.../IMG1020-S.jpg