Well I did say I would be asking questions..... :pride:, this is my first machine build, reading the various build threads has given a lot of inspiration, hopefully enough to get the design right with a little (lot!!!) of help. This is a DIY "at home" project, and am looking to minimise any external machining etc. so lathe and hand tools mainly
Base for router, mainly wood, if I can get design right then a small amount of non ferrous as well (would be nice for small parts)
work table is 900 x 800 and about 220Z, so am expecting about 900x 700mm max machinable width, overhangs on rails sufficient to maximise work area and allow edge drilling at one end, clean pass through to allow longer if required
Structure is 50x50 and 100x 50 steel box, welded. Support rails for linear track is bolted to allow alignment with epoxy putty or shims between plates and if required tig brazed/tacked to secure. Ends are bolted on to improve rail stability and allow adjustment, bolted in place and the drilled & reamed for pins.
http://www.mycncuk.com/attachment.ph...id=14073&stc=1
To me this feels over engineered..
any thought, suggestions or observations gratefully received