http://www.zappautomation.co.uk/elec...-supplies.html
edit you beat me to it or build one
Printable View
http://www.zappautomation.co.uk/elec...-supplies.html
edit you beat me to it or build one
I googled it.
This might help answer - http://www.cnczone.com/forums/genera...-steppers.html
This driver is a three phase driver (For Three phase stepper motors) Looking at the part number it implies that the maximum voltage is 80V DC and the current is 6.0 A.
3 = three phase
M = Motor driver
8 = Max voltage (80V)
60 = 6.0 A maximum current.
This is the typical makeup of the part numbers.
Thanks Gary. I looked on your and a few other sites to try and find who makes this driver, but no such luck.
I also know little about the motors, it was all fit by someone before I bought the lathe. Not a bad job overall. The PSUs that failed looked to be fairly high end things, but voltage is only 24V.
Using that search phrase, Ive found this, similar.
http://www.ebay.co.uk/itm/CNC-3-Phas...p2047675.l2557
https://www.dhgate.com/product/new-c...126671364.html
I might be able to find the manufacturer spec eventually :hurt:
Bingo, I think.
http://www.jmc-driver.com/h-pd-155.h...M860&_pp=0_334
Yes RMS, have big manly fingers and the a and the s are quite close.