Hi
My Bob is a ZP5A - INT from ZAPP.
Ray
Printable View
Hi Jazz
I had i minor wiring fault, i had not stripped the insulation back far enough on one cable therefore there was no contact. Since i corrected this, all 3 of my motors now move, my Z & X axis are ok the drive that did not work yesterday now chatters when i select it on the toggle, i have checked the dip switches, they are set to 4.2 amp, any more ideas?
My Ena + & Ena - were connected, i have disconnected them.
Hi all.
Many thanks to all you people who have given me advice, my CNC MILL is now "HOMING"
Regards
Ray