Printable View
hi i have been looking into getting steel dies made and i have come to the conclusion that i could make the dies on a kx3 if i could get someone to write the program for me as im a novice in 3d but have loads of experience in 2d drawings etc any help or guidence would be greatly appricated thanks
Do you have any drawings/photo's/sketch's that you can post to give us an idea of what you are after.
Do you have a KX3 already? if so what tooling do you have available for it?
http://www.fabricauto.com/us/index.p...ssrub=6&page=3
i will be getting a set of dies with the outside measuremnets the same but with different inside fonts etc i will post a picture of what i mean. the link is for a company that used to make them but dont anymore. i dont have a kx3 as of yet but my local supplier is going to allow me to use it to see if it will do my job ok. As for the tooling i dont know what tooling i should be using etc thanks in advance PatrickAttachment 2123
ive downloaded a demo of v carve pro and you can import the fonts straight into it . i just wouldnt know where to start with making the 3d with radius etc . hopefully i can get this problem solved soon thanks again
hi this is what i am after i will provide more detailed drawings if i can get someone to take this job on thanks in advance PatrickAttachment 2214
photosAttachment 2215
Patrick emails to you keep bouncing.
hi sorry about that john my email address is either : [email protected] or [email protected] i would like to hear from you thanks again Patrick
Patrick, check both emails again please.