Need to get lead screw turned down - Rotherham area
Hi
I've finally go back to building the hot wire cutter but I'm struggling to get the lead screws which are M10x1.5 thread rod connected to my stepper motors. I basically need to get one end turned down to 1/4" to match the motors. Does anyone know of anybody in the Rotherham area with a lathe that can do this. I don't mind paying for it as long as its reasonable
Re: Need to get lead screw turned down - Rotherham area
you could always look in the yellow pages
rckeith
Re: Need to get lead screw turned down - Rotherham area
you can buy couplers with different sized ends, if the ballscrew has a turned diameter already.
Re: Need to get lead screw turned down - Rotherham area
Quote:
Originally Posted by
i2i
you can buy couplers with different sized ends, if the ballscrew has a turned diameter already.
Sounds like it's threaded rod not ballscrew. Either way I could do it, but I'm quite far away...could post it I suppose. Probably cheaper for me to buy the threaded rod (about £5/m for M10 stainless), machine it and post.
Normally I'd advise against threaded rod as the efficiency and accuracy is not great, unless you use the angled bearing as a nut method that I started off with. However I doubt it matters much for a foam cutter.
Re: Need to get lead screw turned down - Rotherham area
it does sound that way..:smile:
you could thread the coupler to suit the leadscrew.
Re: Need to get lead screw turned down - Rotherham area
Quote:
Originally Posted by
i2i
1
you could thread the coupler to suit the leadscrew.
True, but the thread needs to be nicely on centre...
Edit: Well, that depends on the coupling you use.
Re: Need to get lead screw turned down - Rotherham area
it will, all this depends on what he has available. It's easy for us with plenty of gear to suggest options.
Might be an idea to take a look down a nearby industrial estate for a machine shop to sort this.