If you have roughing cutters they work best. I cut all my Z-axis covers and Timing belt covers etc ready for folding and welding with either 6mm or 8mm roughing cutters.
Printable View
I don't have any roughing cutters but OK I'll get some and try it next time I have some panel work.
Also for some reason in the last reply my 'thumbsup' symbol came out as '??' which kind of changed the meaning of my reply! Not sure what happened there or if my browser is at fault or it is because it was from my phone.
Trying again - :thumsup: OK that seems to have got it.
Time for episode 3 - main electrical cabinet . . .
https://www.youtube.com/watch?v=F-pVtiMvjfY
More shenanigans . . .
This time - finishing off the electrical cabinet and getting it mounted, starting the control box, and stripping down the drill press . . .
https://youtu.be/n_qHrwWYRM8
If you are following along, here is episode 5:
https://www.youtube.com/watch?v=DG4HozR5-7w
Ran into a few issues . . . but made progress
https://youtu.be/xtBs0Fxs0so
I decided to have an initial look at these Banggood 20 mm linear rails and 1605 ballscrews . . .. plus a bit more progress on the machining.
https://www.youtube.com/watch?v=O2gPxOmKXAk
More machining and then the motor installation!
https://youtu.be/evFaIQK1RIE
The control box is installed and we get the motor parameters sorted and running. Plus some other jobs along the way.
https://youtu.be/SYwBaAelUD0
You wait weeks for a video then 2 come along together. Here is the next instalment !
https://www.youtube.com/watch?v=ks8m2LqkdwI