I think all is self explaining from manual:
Attachment 23109
Only 3 cables you need. Ground is connected in the VFD as far as i remember
Printable View
I think all is self explaining from manual:
Attachment 23109
Only 3 cables you need. Ground is connected in the VFD as far as i remember
Hi,
Yes i figured it out. You have to wire it as the manual, however the VFD is slightly strange as you have to ground both the ACM & DCM (Analogue & Digital Grounds) to each other. A bizarre occurrence to me, not sure what the Chinese logic is behind it but it works. I can now control the M3/M5 commands and set the speed from the DDCSV1.1.
Alex
Sadly YouTube's closed caption translation feature reads like a Chinese written manual and I don't speak the language used :-(
A written review to accompany the video might reach a wider audience?
- Nick
I like you fitted the controller it looks great. I seem to have an issue with mine now where; if i leave it powered down for long than 5 minutes or so, when i boot it back up, it doesnt boot first time, instead i get a long beep and the backlight of the display, if i switch it off and back on again it works perfectly, very strange.
Thanks
Alex
In DDCSV2.1 change PNP inputs to NPN!
I use CAMBAM. It lets me change between inches and mm.
I already have many files created in inches. Changing them to mm instead of inches seems to make no difference.
When I try to run one in inches it seems to run in mm instead of inches.
My spindle is calibrated to move 25.4mm to get 1in of travel, so assume if I increased my numbers 25.4 times I would get what I want. Except I don't want to go through my files and convert them manually.
Am I missing something to get files to run at a 1 on the display = 1in ???
Thanks for your responses so far guys!