thanks Patrick
Printable View
thanks Patrick
I presume you mean a pair of dies in steel for stamping ?
Attachment 2078
Click to enlarge.
If so then the KX3 will have no problems doing this.
.
in a vector format etc thanks again
The Mach3 software won't do drawings, it's the controller software for the machine and reads G code that's been done by another program.
I did the two 'nearly' matched sets last night in Vectrics, VCarve pro.
I just used a font and made one female and one male but in real life the male one has slight radii in the corners equal to the tool radius.
To work as a set of stamping dies the female one will need the same radii so it presses and not cuts.
I could do the programming if needed.
thanks again for any help cheers Patrick
hi i am wondering would the kx1 do the same job for me as its abit cheaper and i dont need any bigger sizes thanks for you help john