Printable View
Hiya guys and gals,
I've snooped on this forum on and off.
Now I'm serious about getting started.
ive been learning fusion 360 and have been doing quite well.
currently I'm 3 years into 3D printing using auto desk inventor. I have a Facebook page called RC-Truck-Design where for the curious you can see the 1/14 scale truck cabs.
I've got a Boxzy machine which is a new machine.
am yet to actually use it as I'm still needing to understand feed rates.
hope to get some chips soon.
Becky
Hi Rebekah
Welcome to the forum
Fusion 360 is a great bit of software. I'm sure you've found it already but if not check out John on YouTube nyccnc for Fusion Friday hints and examples
Hiya routercnc,
I haven't come accross him so I will check him out. I've been watching Lars christiansen who does a great introduction to the software.
I am going to ask about feedrates in this forum as this is the only thing that weighs heavy on my mind.
regards
becky
Lars is good too. Great thing about John is the enthusiasm and the fact he shows things from a users point of view
have you got a link to his videos?
Is this you are looking for:- https://www.youtube.com/watch?v=AMh2TnfPsaYQuote:
Originally Posted by Rebekah_harper