Welding looks good, but the garage looks nearly full!!! G.
Printable View
Welding looks good, but the garage looks nearly full!!! G.
Sounds like an interesting garage set-up. What is the hot-rod? Even with your garage looking so full it is 20x tidier than mine. G.
It could always do with being bigger and tidier..LOL, Its a 1932 Ford 5 Window on a 1940 Chassis, or will be, it should look a little like this..Attachment 8391
..
Rick
WOW! Seeyou on Sunday. G.
Sweet ride, reminds me of a TV show I used to watch, American Hotrod based on Boyd Coddingtons custom shop.
Ok today I hooked up Mach3 to the X Axis, Arrived at 200 steps Per/400mmMin/100Acceleration in motor tuning, Now here is where the brain goes mushy and i know ive asked this question before, The Gantry travels 2000mm in 18 seconds, the ballscrew is 10mm pitch, how do the settings in mach3 and the actual speed of the gantry relate to each other..
Rick
Ok i think i have it.. LOL
200 Steps per Rev x 8 microsteps = 1600 / 10mm pitch screw = 1600/10 = 160 steps per unit. not the 200 i put in, not sure what that will do when i put it in tomorrow when i get in but i will let you know.
I knew ide asked before lol
http://www.mycncuk.com/forums/machin...-mach-3-a.html
Rick
I was still trying to work out what the question was!