Originally Posted by
Lee Roberts
Welcome to the forum!
Following along also, on first sight I did think "oh the webbing on that looks a bit thin for this", then I read the post and viewed the last image :) certainly looks well made...
Edit: Seen the website dont need an answer to this question.
The M12 is nice, is it the correct hole size for tapping or just close enough, Vallder is a new one to me so will be off to their website in a mo, do they design this profile for this specific application with regards to everything fitting nicely (rails, bearings etc) or ?
Are you making the plates yourself or do you have help with those?
Concrete
What type and mix are you using, standard Portland type isn't really up to the job you know, may be able to advise you here if you don't know why?
Ooo El Beast is a personal fav over here to :applouse:
Edit: Also if not to late etc, it is usually done that the linear rails for the Z Axis would be installed on the Spindle plate, with the bearings being mounted to the gantry in a fixed position, making the distance from the bearing to cutter tip a variable distance rather than a fixed distance?