Re: Adjusting speed with vfd
Amazing. 41 people have looked at this post and none of them seems to have known how to adjust the speed of a spindle using a vfd. I realise probably the up and down arrows are the answer and my problem is that I have a faulty control pad. I was just wondering if I was missing anything obvious.
Bruce
Re: Adjusting speed with vfd
It depends on the VFD.. with one of mine I have to press RUN, then select the 'Hertz' display mode, then the up and down arrows control the speed; with the other I have to select SET 01, up/down, Enter...
If you said what VFD it was make/model you could get a better answer... :)
Re: Adjusting speed with vfd
Dont use the keypad. Fitted a pot and use that instead.
Re: Adjusting speed with vfd
Quote:
Originally Posted by
Web Goblin
Dont use the keypad. Fitted a pot and use that instead.
That works too... as long as you know the key sequence to enable it lol
Re: Adjusting speed with vfd
If you said what VFD it was make/model you could get a better answer... :)
:cower::cower: OOps
INPUT:3PH380V50Hz
OUTPUT:3PH380V17.5A7.5KW
Freq-Range: 0.1~400Hz
HUANYANG ELECTRONICS CO., LTD.
Re: Adjusting speed with vfd
Quote:
Originally Posted by
irving2008
It depends on the VFD.. with one of mine I have to press RUN, then select the 'Hertz' display mode, then the up and down arrows control the speed; with the other I have to select SET 01, up/down, Enter...
If you said what VFD it was make/model you could get a better answer... :)
THATS IT sorry thats it. I knew it was something simple. Thank you sooooooo much.
Re: Adjusting speed with vfd
Re: Adjusting speed with vfd
That is the one. I had the manual but just could not remember how to adjust the speed. Its not clear in the manual and I had forgotten that its the frequency you adjust and then monitor the rpm. Thanks for your effort Adie