As it says on the "Tin":
http://www.ilewis.plus.com/images/leds/tn_calcnote1.jpg
:beer:
Printable View
As it says on the "Tin":
http://www.ilewis.plus.com/images/leds/tn_calcnote1.jpg
:beer:
Just be careful, that equation assumes the LED requires 20 milli Amps of current, the proper equation is (Vsupply - Vled) = IR, or R = (Vsupply - Vled) / I in this case. V is in Volts, I is in Amps, and R in Ohms.Quote:
Originally Posted by Lee Roberts
20 mA = 0.020 Amps.
Some minature LEDs go pop on less than 20mA :)
Technically speaking LEDs require a certain current, not a certain voltage, so it is possible to run a LED from a higher voltage supply without a current limiting resistor, as long as the supply is switched so that the average current is at or below the LEDs forward current.
I'm using this online calculator - you will also get the power requirements for the resistor - it calculates the Wattage of the resistor - depending of the voltage of the circuit
http://led.linear1.org/1led.wiz