Re: gcode stops mid way can anyone test..
Or switch to LinuxCNC which is free but you will need to set up your whole machine again.
Re: gcode stops mid way can anyone test..
all sorted, it was the licsense, thanks all....
Re: gcode stops mid way can anyone test..
Quote:
Originally Posted by
2e0poz
Or switch to LinuxCNC which is free but you will need to set up your whole machine again.
Only take 4 1/2 years....................................
Re: gcode stops mid way can anyone test..
Quote:
Originally Posted by
John S
Only take 4 1/2 years....................................
Is that from personal experience? That's not something I would be proud of.
Re: gcode stops mid way can anyone test..
LOL! i'm sure John could do it quicker than that
Re: gcode stops mid way can anyone test..
Quote:
Originally Posted by
Jonathan
Is that from personal experience? That's not something I would be proud of.
I did nip down the pub for a pie and a pint in that time as well :emmersed:
Re: gcode stops mid way can anyone test..
Quote:
Originally Posted by
John S
I did nip down the pub for a pie and a pint in that time as well :emmersed:
I dread to think what state you were in after 4.5 years in the pub!