Thanks for the link. Are they a decent company/reasonably priced?
Yea, its only a 7mm shaft on the stepper I have. What voltage could my stepper be run at?
Printable View
Thanks for the link. Are they a decent company/reasonably priced?
Yea, its only a 7mm shaft on the stepper I have. What voltage could my stepper be run at?
Thanks jess. I wouldn't trust myself with chemicals, played around with them too much when I was younger!! :hypnotysed:
Think I'm just gunna make one for wood and ali now. I just wanted to see if steel work was viable at my price point, it wasn't essential. It would have been handy to make a few bits for work, but it's no big deal.
I believe so.
I personally buy them from Zappautomation , cause at the time it happened that he responded faster my email. Plus he is active here at the forums. If i was in UK i would buy all from him. Now i buy a lot of stuff directly from China, due to the low euro/gbp and shipping costs involved of receiving materials here in Spain.
But if i learned one thing with the CNCs is that the main and most important thing you buy is the support, so many times saving a couple of $$ could result in weeks frustration and inability to produce during that time.
Thanks. Shall check them out too.