Re: first move not clearing material
Re: first move not clearing material
Quote:
Originally Posted by
JAZZCNC
Tut tut Mark you wasn't paying attention was you when I showed you last time. . .Lol
If get done early enough tomorrow (fri) I'll call on way from work and show you.
PMSL because the amount of info remember its an old brain you are trying to get it in lol
Re: first move not clearing material
Re: first move not clearing material
Quote:
Originally Posted by
Ger21
It's SolidCAM's responsibility to lift the tool, not Mach3.
Mach3 just does what SolidCAM is telling it.
Isn't it the responsibility of the author of the PP?
Re: first move not clearing material
Quote:
Originally Posted by
magicniner
Isn't it the responsibility of the author of the PP?
No it's the responsibilty of the Muppet using the Cam software to set the Safe Distance height.!!:dejection:
Re: first move not clearing material
I've never had the issue but then it never occurred to me to zero the tool to a surface, turn the spindle on and hit GO!
:D