Printable View
Hi,
I'm also looking for a CNC service to make some vintage camera parts for me. I'm imagining that there should be a service out there, but several hours on the web hasn't turned up much except for eMachineShop.
BTW I did find CNC for motorcycle parts (see below).
Regards,
Alan
http://www.themuttznutz.com/
http://radicalcustommotorcycleparts.com/
http://www.cjs-engineering.co.uk/
I should say that the service would ideally take a supplied cad file rather than drawings.
Alan
Do you have any drawings or photo's of the type of parts that you are after, anything to give us an idea will do for now.
OK a dxf and some slightly dodgy jpgs. Of course being vintage, the tolerances are not bothersome +-0.5mm should be fine.
Alan
1.39 metres ?
Is this for Jodrell Bank?
.
139mm x 4mm although I like the sound of 4cm aluminium a lot :)
Alan