hi
what do the folks on this site think of the 4 axis tb6560 motor driver
Printable View
hi
what do the folks on this site think of the 4 axis tb6560 motor driver
Here are a couple of threads that will give the general idea...Quote:
Originally Posted by uppy121
http://www.mycncuk.com/forums/motor-...er-boards.html
http://www.mycncuk.com/forums/motor-...ay-update.html
I Suspect there will be a few people using them who have no problems, but i understand they dont like to be pushed, it that is the word..
Rick
In a short reply - Crap
John!!Quote:
Originally Posted by John S
:hysterical: I was trying to be polite :hysterical:
Rick
hi
what else can i use
Her who must be obeyed has given me permission to buy three of 2M542's and the board that goes with 'em although I've noticed 542H - emailed the seller as to what the H is but no response yet, if I don't get one within the next few days I'll just grab the 542's as the price difference is an additional 60+/- a bit quid all up. . .Quote:
Originally Posted by John S
Addon Bit: Found out the difference, the 542 has a typical supply voltage of +36, whereas the 542H has a +50
Carl
I run my 542's (or 2m542, same spec) at 42v the 'H's can run at slightly more current i believe (4.5). For your set up the standard 542's will be fine, ignore the +50 bit as well. 50v is really max for these drivers.