OK I will leave it well alone
Luke is really playing on his wrist
Printable View
OK I will leave it well alone
Luke is really playing on his wrist
Kids who'd have em eh. . Lol
I'll try and dig the Xray out of my lads smashed wrist with pins, screws and titanium rods so you can use it as ammunition to show him it could be worse. . . Maybe also put him off expensive motoX as well if your lucky. . lol (Didn't work for my lad thou.!!)
Cool Jazz
do you want to see a x-ray of a pace maker??
James
Did you get to keep the titatium? Useful stuff...
If I'd known I wouldn't have shown him my wind turbine as there's lots of big magnets in that. Field is pretty enclosed so should be fine. I've since moved the big neodymium magnet I had left stuck to my lathe just in case!
Thank's people and yes Jonathan I did see the big magnet on the lathe
I had to go for a recalibration this week as I walk through a security point and then realized it was a big magnet one
I'm so lucky it doesn't happen to often:surprised:
I was at the court house(in Leicester) paying a old old speeding fine from March
I now have 3 points on my licence and i was only going to the f***ing dentist
James
Yes I was really poorly at Christmas (swine flu) and as a result I smashed three teeth as I hit the floor a bit to fast as I past out, But the pace maker kicked in and I came around pretty quick( go job it's working)
I also ended up in A&E at one point as I went over in the dentist (police and ambulance turned up) I felt such a fool.:redface:
The teeth cost me a small fortune £600.00 lab fee's alone glad I'm covered on denplan
James
well I've tried to get all rails and ballscrews on one plane as suggested and recommended by Jonathan but I can't
Yes yes I screwed up
my gantry is to short
so I have gone with this But I am open to suggestion
Attachment 4552
I am going to use 50x100 mm extrusion as my main support for the rails and bolted to 6" aluminium
James & Luke