Its just finished its program. still looks wrong :confusion:
Printable View
Its just finished its program. still looks wrong :confusion:
You still didn't post the dxf file
has this worked Eddy ?
This is the one tried to smooth out on Cam Bam
http://i956.photobucket.com/albums/a...ones/mycnc.jpg
Yes that file loaded okay
Is there any clue why it's doing the angular curves ?
There were some lines that would not join, I've fixed them in the attached file, but it should not have caused your issues.
This what it looks like in the CutViewerMill simulator
Attachment 14213
Are you using 'constant velocity' mode or 'exact stop' ?
Cheers Eddy,
im afraid I don't know about constant velocity or exact stop ?
ill draw something curved on the boxford software tomorrow and try it but it's been doing other curves fine before, just this one I think has been a bit odd .
Maybe try it again with the file I just sent, but the toolpaths in your picture look okay so will probably not help.
In CamBam have a look in the Engrave MOP settings, you will see one called 'Velocity Mode'
Hi Eddie
Just the same mate :-(
When the Boxford software draws the image before cutting its fine, just like yours. just when it cuts its all angular.
What do I do with velocity mode ? Im new to Cambam and cnc in general so im struggling here.
How can I re-draw it? I can over draw in draft site I believe but I dont know what tools etc to use on the software
Ta
Carl