Thread placement and plea for help
Hi folks,
I want to start a thread re: a machine I have acquired
It is a 3Axis mill designed to mill Orthotics but was being scrapped (too long a story for here).
My questions will mainly be Electrical based ...
So which sub forum to gain most coverage/knowledge??
Cheers
Tim
Re: Thread placement and plea for help
Quote:
Originally Posted by
Wobblybootie
Hi folks,
I want to start a thread re: a machine I have acquired
It is a 3Axis mill designed to mill Orthotics but was being scrapped (too long a story for here).
My questions will mainly be Electrical based ...
So which sub forum to gain most coverage/knowledge??
Cheers
Tim
Hi and welcome. There is a general area or DIY one like this - http://www.mycncuk.com/forums/253-DIY-Router-Build-Logs - im sure the Mods will help move if its in the wrong area.
Re: Thread placement and plea for help
Cheers Chaz, I'll stick it into general and see what transpires.
Re: Thread placement and plea for help
Hi Tim
Welcome back to the forum again!
Either the sections from Chaz or look on the main page for the electrical tab. The electrical system you want to ask about might already have its own area in there or there is a general electrical area.
Re: Thread placement and plea for help
Thanks, I may try stuffing it into the Machine discussion section as the damn thing is a bit of a puzzle and a challenge at the same time. I may get more responses re the machine first then the sparky smoky bit ...