2 Attachment(s)
need an experienced eye to cast a look over this driver
got these from a scrap machine, as they look quite professional though maybe i could use them on my upcoming build, i considered if i could connect the break out board correctly it should work (should is the magic word), after all it only needs a few wires connecting to get it going, i did like the fact it only needs 240v kettle lead to work , no need for power supplies although i did get a switchmode supply and a 4 way indexer which im sure i dont need, cheers Nik
Attachment 9455
Attachment 9456
Re: need an experienced eye to cast a look over this driver
btw machine was scrapped due being a spare and then technology left it behind
Re: need an experienced eye to cast a look over this driver
Looks like step and direction into 1 and 2 then 14 and 15 link together and go to ground on the BOB
No idea how you set amperage though ?
Re: need an experienced eye to cast a look over this driver
any part numbers or other identifying marks?
Re: need an experienced eye to cast a look over this driver
Quote:
Originally Posted by
John S
No idea how you set amperage though ?
Looks like the dip switches at top John.?
Can you show pic of those switches Drnik.
Re: need an experienced eye to cast a look over this driver
The bottom 3 switches of the top bank are labelled 'motor curr'. Also 2 switches labelled 'resn' I'd guess are microstep setting?
More intriguing are the 'setup' trimmers for accel, etc.
Re: need an experienced eye to cast a look over this driver
Hi John
We use this Parker equipment at work send me a pm with the model numbers I think we will have the manuals for them.
Andy
You can tell I hav'nt been on here for a long time!
Nick send me your details including model numbers I,m sure I can help.
Re: need an experienced eye to cast a look over this driver
Quote:
Originally Posted by
irving2008
The bottom 3 switches of the top bank are labelled 'motor curr'. Also 2 switches labelled 'resn' I'd guess are microstep setting?
More intriguing are the 'setup' trimmers for accel, etc.
Hi Irving
These are used with DIP Switch 3 where you can have internal speed control.
3 Attachment(s)
Re: need an experienced eye to cast a look over this driver
well cheers Andy, i'll post these pictures
Attachment 9494
Attachment 9495
i also got this as it was attached to the 3 drivers, im not going to be using it,
Attachment 9496
Re: need an experienced eye to cast a look over this driver
Manual here http://www.parkermotion.com/manuals/PD/PDS_E.pdf
2.5A min, 5A max driver in 350mA steps
step settings 400, 1000, 2000, 4000 (i.e. 1/2, 1/5, 1/10, 1/20)
opto-isolated inputs
regenerative dump circuit