Re: Work Holding Tape/glue
so following on from this threat I decided to do some R&D with different glues and ive found a winner.
http://www.screwfix.com/p/no-nonsens...ve-200ml/41795
I also purchased the cheapest 50mm wide masking tap from screwfix and it all worked a treat.
I used this method but with the glue from screwfix
https://www.youtube.com/watch?v=3uTsQ3dYRrk
just done the below, its pretty small at 100mm by 100mm but the gluing method worked 100% perfect and just popped right off once I was finished. I only used a tiny bit of glue so its going to last ages. it dried and was rock solid in about 30 seconds
http://i187.photobucket.com/albums/x...psherguv8h.jpg
next I want to try cutting letter out like this
http://i187.photobucket.com/albums/x...pskmmjojmu.jpg
Re: Work Holding Tape/glue
Good Call!
I use Wickes Mitre Bond, an activated cyanoacrylate, and an aluminium tool plate when I'm machining and/or profiling small parts from gauge plate, stainless and titanium on the milling machine.
- Nick