Re: Sieg SX2.7 CNC conversion
Thank you! So far everything is working well.
The only problem I had with this quick tool change was that on one occasion the tool holder started to slip out as I cut with an 8mm endmill. The Bellevilles had been tighten by two full turns of the drawbar (after finger tightening) and it seems that the tool wasn't getting enough grip by the collet. So I increased the Belleville tightening to just over 3 turns of the drawbar, and now it seems to be gripping properly. These things always need a little fine tuning...
Edward
Re: Sieg SX2.7 CNC conversion
Quote:
Originally Posted by
njhussey
And pictures, we like pictures 😁
Sent from my HUAWEI VNS-L31 using Tapatalk
Re: Sieg SX2.7 CNC conversion
Old thread I know, Edward, what did you do re. Spindle speed control?, or have you left it manual?
I’m half way through my SX2.7 conversion with many thanks to this thread
Re: Sieg SX2.7 CNC conversione wonderfull
Hi Edward do you have a set of plans available as sx2.7 conversion kits are not available in UK mostly USA I have not seen any plans floating about on internet yet it would be wonderful if you could supply plans in pdf format or even better dfx if you can to help others
Thanks Andrew