Cnc plasma build need help plz
Hi
ive been building a cnc plasma but cannot seem to get the speed up in Mach3
The motors run super slow
im using a dell 755
wantai 3nm motors
leadshine em503 drivers
5 axis Bob off flebay
24v Siemens psu
1605 ball screws
any help will be appreciated by myself and anyone else stuck with this problem
i will post pics of my build so far
but I've gave up on it for now till I can find more info
thanks in advance
lewis
Re: Cnc plasma build need help plz
You have several problems regards speed.?
24V isn't enough voltage you really need around 40-45Vdc to get any decent speed from those motors. I'll Also take a guess that they are high inductance motors which makes things worse with low voltage.
Then you have 5mm pitch screws which will limit your rapid speed.
But to get a better idea of your setup we need more info.
Are you using parallel port.?
Are you using direct drive to screws or do have belts with reduction.?
What micro stepping on the drives.?
What values do you have in Motor tuning. :ie Steps Per, Velocity, Acceleration for each axis.?
When you say slow how slow exactly what's the Max rapid you can achieve.?
Re: Cnc plasma build need help plz
Hi
im using a parallel port
its that slow it is barely noticeable
leadshine drivers have a software called pro tuner
plug a cable from driver to serial port and I can get decent speeds
but in Mach 3 it's super super slow
ive tried all sorts of step per in motor tuning etc
also tried lots of different micro step setting
limits and estops work as they should
motors are direct drive
because they work with the pro tuner software which connects to the serial port Tells me it's either parallel port related or breakout board
thanks
for the reply
Re: Cnc plasma build need help plz
Quote:
Originally Posted by
Lewywri89
ive tried all sorts of step per in motor tuning etc
also tried lots of different micro step setting
That tells me nothing and Steps per isn't something you guess at it's a fixed number dependant on screw Pitch and Micro stepping.
One thing that could be doing this is if you have the Units set to Inch but using Millimeter to calculate Steps per.
Quote:
Originally Posted by
Lewywri89
because they work with the pro tuner software which connects to the serial port Tells me it's either parallel port related or breakout board
No if you can Jog around then everything is working as it should. The only thing that could limit speed is if you have the JOG speed set low.
Re: Cnc plasma build need help plz
Sorry i meant I've tried different steps per just out of curiosity.
jog speed is set to 100%, units are set in mm
Sorry I this sounds dumb I'm still learning and thank you for replying :)
Re: Cnc plasma build need help plz
No don't worry you don't sound Dumb but just saying I've tried all sorts doesn't help anyone help you so that's why said doesn't tell me anything.
Give the Info I asked for and we'll see about getting you going.
Re: Cnc plasma build need help plz
post a screenshot of your mach3 motor tuning page? also advise what the microstepping resolution it. if you are direct drive to the ballscrews and they are 5mm pitch, then it is quite simple to set up.
Re: Cnc plasma build need help plz
Ok I will get back to you tomorrow as I'm not in my workshop at the moment
Thank you
5 Attachment(s)
Re: Cnc plasma build need help plz
Re: Cnc plasma build need help plz
Sorry couldnt figure out how to upload images but ive got it now
I think one of tje leadshine drivers are faulty as there is no power to 1 motor
Hope I can find the problem with it being super super slow
Sent from my D6503 using Tapatalk