Re: Making timing pulley - putting theory into action
Quote:
Originally Posted by
Jonathan
Impressive that your router is rigid enough for that. I did mine on the milling machine using the same process and it clearly put a lot of force on the spindle.
I believe the term is form tool. Not that it's really matters...
I agree entirely. I found it difficult to get a perfect mesh with the belt. The theoretical values for the pulley blank diameter never seemed quite right.
I think it is rigid. Whole construction is milled from 6mm thick steel plate + 100x50 rectangular profile. After I paint it I'll make some pics.
hmm,maybe fly-cutter does not apply entirely. Anyway It's ground from broken end mill to create tooth profile or rather between-tooth-profile :smile:. My cutter rests safely and wait for next job:smile: .
Calculations worked for me:
pulleys PCD radius - 0.381mm gives you pulley radius.
then cut depth if 1.21mm.
However I found slight dimensional variations for pulley dia /doc. I used those from pic uploaded
2 Attachment(s)
Re: Making timing pulley - putting theory into action
I have only done XL series pulleys, so trapezoidal not round. Looks like it's easier to get it right with HTD. Should start replacing mine on the router.
JohnS' makes mine look a bit amateur:
Attachment 4983
Attachment 4984
As those went on my router they've had a lot of use and the pulleys under where the belt runs has got polished. Same is true for the bought ones. I wonder if it's worth anodising them to harden the surface? Would have to be careful not to change the dimensions too much in the process.
Re: Making timing pulley - putting theory into action
Quote:
Originally Posted by
John S
Doing a stack at the moment.
These are 5m's
5M's are a doddle, 1/8" ball nose cutter 2.16mm deep plunged in from the OD which you can get off the HPC website.
For 3M's you need a 2mm ball nose 1.28 deep.
That's how mass production looks like:smile:
Very good job anyway. I like the side rings which I couldn't be bothered :whistling:
Doesn't fly cutter do job faster???
I ran 300mm/min @ 1.21mm doc and I would dare to do 500 easy. 2mm ballnose could be very flexible as well.
Again very good looking pulleys, John
Re: Making timing pulley - putting theory into action
Quote:
Originally Posted by
Jonathan
I have only done XL series pulleys, so trapezoidal not round. Looks like it's easier to get it right with HTD. Should start replacing mine on the router.
Does somebody buys the pulleys??? :lol:
The only issue I encountered was to set mandrel center in RT. After bit of playing with DTI I managed to set it up.
Re: Making timing pulley - putting theory into action
Quote:
Originally Posted by
wiatroda
Very good job anyway. I like the side rings which I couldn't be bothered :whistling:
Doesn't fly cutter do job faster???
The flanges are nice. You should use 2 to 4 per pair of pulleys, depending on the orientation.
Ball nose cutter puts less load on the spindle, so less wear? More likely reason is probably that it's harder to grind an accurate 3mm form tool (unless you've got the right equipment) than to just use a ball nose cutter.
Re: Making timing pulley - putting theory into action
Quote:
Originally Posted by
wiatroda
Does somebody buys the pulleys??? :lol:
I got a selection of XL cheap on eBay ... other than that, no I don't buy them.
Quote:
Originally Posted by
wiatroda
The only issue I encountered was to set mandrel center in RT. After bit of playing with DTI I managed to set it up.
I did the same. Since it's a 3 jaw chuck I just did the bolts up not quite fully and tapped it into position.