Printable View
I have cnc router have 3axis when I see control unit I see it have 5drivers instead of 3
3 of them have same thickness and 2 have another thickness
what is the role of small drivers !?https://uploads.tapatalk-cdn.com/201...b3e17e0a66.jpg
Sent from my ASUS_Z00A using Tapatalk
Follow the motor cables to the motor, that will tell you.
5 drivers could be for dual motors for Y (or X)? Is there a 4th axis? Is the spindle controlled by a drive?
no spindle have dedicated VFDQuote:
Originally Posted by Chaz
so If I have dual Y
Can I connect on the same output from interface board!!?
RichAuto Dsp A15 https://uploads.tapatalk-cdn.com/201...23221cb165.jpg
Sent from my ASUS_Z00A using Tapatalk
I dont know, not done any slave connectivity before. Im sure JazzCNC or others will offer some guidance.Quote:
Originally Posted by alaamomen9
What do you mean by "If I have dual Y " you either have or have not!!Quote:
so If I have dual Y
Can I connect on the same output from interface board!!?
You have not answered Chaz re "follow the motor wires from the drives"
Pic off the machine might help. more info required
manufacturer has used dsp0501Quote:
Originally Posted by Clive S
when I see manual of dsp It was support step motor only !!
so what is corrert manfacturer or manual !!?https://uploads.tapatalk-cdn.com/201...a38a696ca5.jpghttps://uploads.tapatalk-cdn.com/201...c62ff34f78.jpghttps://uploads.tapatalk-cdn.com/201...c12ff92f51.jpghttps://uploads.tapatalk-cdn.com/201...9e1201fcfd.jpghttps://uploads.tapatalk-cdn.com/201...0c97cfa7b4.jpg
Sent from my ASUS_Z00A using Tapatalk