Hello to all,im from Croatia,employed as maintaining maschinist,bulding first CNC mill,hardware is almost done,I post some pics when i finish.(sorry for poor english)
Printable View
Hello to all,im from Croatia,employed as maintaining maschinist,bulding first CNC mill,hardware is almost done,I post some pics when i finish.(sorry for poor english)
Hi Smiler,I post some pics tommorow,its a small proper mill,my first design,whole from steel.Have no time to finish,to much work at job.
Thanks for interest.
Hello Jeff,you are right,but sometimes its better to think twice before proceeding.I already posted some pics, i dont know where they are!I am going to post them again.
http://www.picturehosting.com/images.../dsc034722.jpg
http://www.picturehosting.com/images.../dsc034792.jpg
http://www.picturehosting.com/images.../dsc034802.jpg
http://www.picturehosting.com/images...1dsc034611.jpg
http://www.picturehosting.com/images...1dsc034601.jpg
Now thats an impressive little beastie :D
what are you going to use as a spindle?
Thanks for all your positive feedbacks.In the matter of the spindle,I'm not going to use anything large in first setup,one dc motor 200w3350rpm and a spindle I made myself.Spindle housing of steel with small head(one collet diameter;have few pieces of these,3,4,5,6,8 holes),I have some angular bearings(7201C),and I think it will be good for the first run.Later,I have in mind spindle with morse 3,ER20 collet chuck,which I also plan to do myself,and servo motor with VFD.:beer: