Aluminium stock (billet/plate)
Where do you guys buy your aluminium for machining?
I'm after some offcuts for practising with, eBay is usually my go to online store, but most on there seems pricey. To the point where I couldn't buy the raw material for the same cost as a fully CNC machined part from the USA including shipping...
I'm in the north west England, and can travel for a good supplier.
I have a local steel stock holder, but want to start on alu.
Would welcome any pointers please chaps.
Re: Aluminium stock (billet/plate)
I'm down in Gloucestershire so my local supplier, Taybroh Alloys, is a good way from you...
Sent from my HUAWEI VNS-L31 using Tapatalk
Re: Aluminium stock (billet/plate)
Quote:
Originally Posted by
Dangle_kt
Where do you guys buy your aluminium for machining?
I'm after some offcuts for practising with, eBay is usually my go to online store, but most on there seems pricey. To the point where I couldn't buy the raw material for the same cost as a fully CNC machined part from the USA including shipping...
I'm in the north west England, and can travel for a good supplier.
I have a local steel stock holder, but want to start on alu.
Would welcome any pointers please chaps.
I live in Preston and I have struggled to find a good local Ali supplier, so far I have used eBay. If your looking for scrap lumps to mess with you could try Recycling Lives at Red Scar 01772 654321 They have a huge scrap recycling place and I've seen piles of ali outside. They may let you buy some bits off them.. not sure.
Re: Aluminium stock (billet/plate)
Quote:
Where do you guys buy your aluminium for machining?
Not the cheapest but I have found them OK.
http://www.aluminiumwarehouse.co.uk/...Bar/pages.html
Re: Aluminium stock (billet/plate)
Re: Aluminium stock (billet/plate)
Jazz CNC just some plate or square to start making some cuts into, reasonable thickness as I don't have much in the way of work holding. Maybe 10mm thick, and length/width any size really, as long as it's big enough to clamp down
Re: Aluminium stock (billet/plate)
Quote:
Originally Posted by
Dangle_kt
Jazz CNC just some plate or square to start making some cuts into, reasonable thickness as I don't have much in the way of work holding. Maybe 10mm thick, and length/width any size really, as long as it's big enough to clamp down
Ok well I've got some offcuts mostly 15-20mm that will let you have just cover postage. PM me your address and I'll Dig you some out but it will be next week now.
I'll sort you few different grades as well.
Re: Aluminium stock (billet/plate)
Re: Aluminium stock (billet/plate)
Quote:
Originally Posted by
Clive S
I buy from them, always +0..2mm with any dimension you give