Do you have access to the Micro-Stepping settings for the drivers?
Printable View
Do you have access to the Micro-Stepping settings for the drivers?
They are all switched the same, first and last are X axis https://uploads.tapatalk-cdn.com/201...d4cf8c089c.jpghttps://uploads.tapatalk-cdn.com/201...ca30866fbe.jpghttps://uploads.tapatalk-cdn.com/201...949ca073ab.jpg
Sent from my F8331 using Tapatalk
Have you calibrated your motors when got got the machine I have the same machine and had the same problem...1st u have to figure the settings for the steps on your motor then you need to calibrate the motors. Let me know if you need ant help as far as settings
I have this same machine did you calibrate your motors in mach3? 1st set up a dial indicator and see if it moves what you tell it to move if not you need to adjust your steps in ports and pins in mach3 . Let me know if u need any help