Hi Clive,
The smoke came from the component in small red circle. Before smoke - it got very bright...
It was only 12V power wires connected to the BOB from 12V supply.
Attachment 19461
Printable View
Hi Clive,
The smoke came from the component in small red circle. Before smoke - it got very bright...
It was only 12V power wires connected to the BOB from 12V supply.
Attachment 19461
Hi,
Finally received new HDBB2. Connected and all looks good - I can drive all axis finally :) Only one issue - don't know why, UC300, when connected to external power source of 5V (jumper settings correct) my pc does not see the board connected... Once I disconnect external power source, reposition jumper to use 5V from USB - PC can see the board and all works just fine ? Any ideas why is that and is it ok to use it without external power source ?
Also, I'm bit confused how to drive relays from two different sources. I want to use outputs from HDBB2 and UC300 to activate relays. Here is a diagram how I connected it at the moment:
Attachment 19476
But, the relays is not working that way... (I can activate them via Arduino with that wiring though). I could use this type of connected (external power supply connected to power relay coil, but from where I shall take 5v to activate relay ?)
Attachment 19477
Could anyone help / guide me how I shall wire the relay board ?
Thanx :)