. .
  1. Good day all.

    As per the title, what is the optimum voltage for my M60STH88-3008DF steppers and 752 drivers?
    I am still using one of the 42volt ex-BT eBay power supplies.
    Thanks for your time.

    Best Regards.
    "If first you don't succeed, redefine success"

  2. #2
    Working on the general 32xSqrt inductance rule then 57Vdc is the safe option but I know they will happly take more without shortening the motors life too much.
    I nearly always run them at 65-68V mainly because that works out nice for 625Va 24x24 transformer and still keeps a safe margin on the drives 75V limit.

  3. #3
    Quote Originally Posted by JAZZCNC View Post
    I nearly always run them at 65-68V mainly because that works out nice for 625Va 24x24 transformer and still keeps a safe margin on the drives 75V limit.
    Same here...can get away with 25+25V transformer but no real need to push the limit.
    Old router build log here. New router build log here. Lathe build log here.
    Electric motorbike project here.

  4. #4
    What happened to all the other ansers ? Went into 2 pages earlier.?
    John S -

  5. #5
    Quote Originally Posted by John S View Post
    What happened to all the other ansers ? Went into 2 pages earlier.?
    I didn't see 2 pages John.?

  6. #6
    Quote Originally Posted by John S View Post
    What happened to all the other ansers ? Went into 2 pages earlier.?
    Quote Originally Posted by JAZZCNC View Post
    I didn't see 2 pages John.?
    Nor did I - investigation initiated.
    Old router build log here. New router build log here. Lathe build log here.
    Electric motorbike project here.

  7. #7
    Sorry lads, brain fart - wrong post.
    John S -

Thread Information

Users Browsing this Thread

There are currently 3 users browsing this thread. (0 members and 3 guests)

Similar Threads

  1. Help wiring M60STH88-3008DF Steppers Motors to 752 Drivers
    By Mad Professor in forum Stepper & Servo Motors
    Replies: 12
    Last Post: 01-09-2011, 10:09 AM
  2. Has anyone used these steppers or drivers?
    By Jonathan in forum Stepper & Servo Motors
    Replies: 2
    Last Post: 24-03-2011, 02:24 PM
  3. Boxford VMC 260 steppers voltage?
    By evildrome in forum Boxford Vertical Mills
    Replies: 3
    Last Post: 20-10-2010, 03:03 PM
  4. Steppers and drivers
    By Davidh in forum Motor Drivers & Controllers
    Replies: 3
    Last Post: 12-06-2009, 05:59 PM
  5. High voltage stepper drivers?
    By ZeroCount in forum Motor Drivers & Controllers
    Replies: 5
    Last Post: 26-02-2009, 12:07 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •