. .
Page 2 of 2 FirstFirst 12
  1. #11
    Thanks for the link. Are they a decent company/reasonably priced?

    Yea, its only a 7mm shaft on the stepper I have. What voltage could my stepper be run at?

  2. #12
    Thanks jess. I wouldn't trust myself with chemicals, played around with them too much when I was younger!!

    Think I'm just gunna make one for wood and ali now. I just wanted to see if steel work was viable at my price point, it wasn't essential. It would have been handy to make a few bits for work, but it's no big deal.
    Last edited by amd7000; 05-06-2015 at 11:09 PM.

  3. #13
    Quote Originally Posted by amd7000 View Post
    Thanks for the link. Are they a decent company/reasonably priced?

    Yea, its only a 7mm shaft on the stepper I have. What voltage could my stepper be run at?
    I believe so.

    I personally buy them from Zappautomation , cause at the time it happened that he responded faster my email. Plus he is active here at the forums. If i was in UK i would buy all from him. Now i buy a lot of stuff directly from China, due to the low euro/gbp and shipping costs involved of receiving materials here in Spain.

    But if i learned one thing with the CNCs is that the main and most important thing you buy is the support, so many times saving a couple of $$ could result in weeks frustration and inability to produce during that time.
    project 1 , 2, Dust Shoe ...

  4. #14
    Thanks. Shall check them out too.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. What 'decent' Milling machine?
    By Chaz in forum Milling Machines, Builds & Conversions
    Replies: 74
    Last Post: 21-06-2015, 04:32 PM
  2. BUILD LOG: My 1st Hybrid Steel/Ally (1150 x 850 work area) (comments/advice please)
    By lebies in forum DIY Router Build Logs
    Replies: 18
    Last Post: 19-08-2014, 12:00 PM
  3. eBay: Looks a decent little machine
    By EddyCurrent in forum Items On eBay UK
    Replies: 13
    Last Post: 12-09-2013, 04:55 PM
  4. A decent little (PCB miilling) Chinese machine...
    By HankMcSpank in forum Machine Discussion
    Replies: 5
    Last Post: 18-06-2013, 06:59 PM
  5. Already built my machine.. but some pics of work etc
    By Yohudi in forum Gantry/Router Machines & Building
    Replies: 5
    Last Post: 31-08-2007, 06:15 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •