1. #1
    Hopefully someone can help me with this question.

    I have a Proma 150 THC and on the Directions says connect pin 5 and 6 to the controller. If you at the Hypertherm THC connection it says that pins 5 and 6 are black and white. If you use a continuity tester pin six is Green and pin 5 is black. Has anyone else come across this problem?

    The Proma 150 connected to my board works correct going up and down in test mode but when you run a program it goes up but not down. Torch max is set at 2.00 in and torch min is set at 0.00 inches any thoughts.

    Thanks for any help I can get
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	5 axis breakout board.jpg 
Views:	183 
Size:	60.1 KB 
ID:	18842   Click image for larger version. 

Name:	wiring to proma.png 
Views:	101 
Size:	14.0 KB 
ID:	18843   Click image for larger version. 

Name:	IMG_1247.jpg 
Views:	106 
Size:	295.3 KB 
ID:	18844  


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts