Page 4 of 4 FirstFirst ... 234
  1. Quote Originally Posted by Neale View Post
    This thread has drifted some way from the original question about enable pins on drivers, but I don't think that there has been a definitive answer to that one yet...
    Quote Originally Posted by ROBCNCAU View Post
    Hi all,

    Just wondering if it is necessary to use the enable pins, I notice a lot of setups do not use them. What is the purpose of them? Any drawbacks to not using them?

    You don't have to use them, they are automatically pulled to the enable state by internal circuitry in the drive, if you connect the appropriate external circuit for your drive to pull the enable pin to the disable state the drive is disabled.
    It's down to you to decide if you need this function and what for, if you don't need to disable the drives ignore it as enabled is the default state for common drives,

    - Nick
    Last edited by magicniner; 24-08-2016 at 11:40 AM.
    If you will not be swayed by logic or experience simply pick the idea you
    like best, but ask yourself why you sought advice in the first place and,
    for a simple life, perhaps consider not doing so in future

Page 4 of 4 FirstFirst ... 234

Similar Threads

  1. How to wire the enable pin on a stepper drive?
    By cncJim in forum General Electronics
    Replies: 8
    Last Post: 01-01-2016, 04:10 PM
  2. How do I wire a stepper driver to a stepper motor?
    By swood1 in forum Stepper & Servo Motors
    Replies: 7
    Last Post: 21-09-2014, 04:40 PM
  3. Replies: 1
    Last Post: 16-03-2014, 06:29 PM
  4. best stepper driver???????
    By Ross77 in forum Motor Drivers & Controllers
    Replies: 37
    Last Post: 21-04-2013, 04:05 PM
  5. Boxford 125TCL Stepper Specs required.!!
    By JAZZCNC in forum Boxford Lathes
    Replies: 7
    Last Post: 01-02-2013, 12:28 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts