Threaded View
-
24-08-2016 #7
You don't have to use them, they are automatically pulled to the enable state by internal circuitry in the drive, if you connect the appropriate external circuit for your drive to pull the enable pin to the disable state the drive is disabled.
It's down to you to decide if you need this function and what for, if you don't need to disable the drives ignore it as enabled is the default state for common drives,
- NickLast edited by magicniner; 24-08-2016 at 12:40 PM.
You think that's too expensive? You're not a Model Engineer are you? :D
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How to wire the enable pin on a stepper drive?
By cncJim in forum General ElectronicsReplies: 8Last Post: 01-01-2016, 05:10 PM -
How do I wire a stepper driver to a stepper motor?
By swood1 in forum Stepper & Servo MotorsReplies: 7Last Post: 21-09-2014, 05:40 PM -
Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 07:29 PM -
best stepper driver???????
By Ross77 in forum Motor Drivers & ControllersReplies: 37Last Post: 21-04-2013, 05:05 PM -
Boxford 125TCL Stepper Specs required.!!
By JAZZCNC in forum Boxford LathesReplies: 7Last Post: 01-02-2013, 01:28 AM
Bookmarks