Hi everyone

[Roadrunner]

Hi to everyone just started to build my first CNC machine look forward to sharing the good and the bad times

Most importantly picking your brains

[mekanik]

Hi welcome to the forum.
The first rule is don't but any electrical kit.
Read some build logs, then knock up a design and offer it up for comments of the guys,let us know your intended application and required cutting area ect.
Enjoy
Mike

[njhussey]

Welcome as Mike says read the build logs, start a build thread and enjoy the ride!!!

[Roadrunner]

Hi welcome to the forum.
The first rule is don't but any electrical kit.
Read some build logs, then knock up a design and offer it up for comments of the guys,let us know your intended application and required cutting area ect.
Enjoy
Mike

Hi Mike and thanks for the welcome already a rebel and have bought the electronics which I was sorting out last night I will add some pictures to the build log area shortly

Thanks Steve

[Roadrunner]

Welcome as Mike says read the build logs, start a build thread and enjoy the ride!!!

Does it take time for a new thread to show on the site ?

[njhussey]

I think that to start off threads have to be approved by a moderator if you've not many posts but not too sure....Lee's your man as it's his site...

[Roadrunner]

I think that to start off threads have to be approved by a moderator if you've not many posts but not too sure....Lee's your man as it's his site...

Thanks Neil

Thought I was losing the plot !

[Roadrunner]

Yep losing the plot had another go it worked this time.