Thread: Limit switch problems
Threaded View
-
10-09-2016 #1
Hi. Hope I'm posting in the correct place and apologies if I don't explain problem as I should.
I have a Sherline mill with Routout boards running Mach 3. There are 2 limit switches on each axis. Everything works fine except top (home switch) on z-axis. Switches are NC (normally closed).
It isn't a faulty switch and seems to be connected properly to the board however nothing seems to detect it. The bottom z axis switch works fine. I can upload any pics, config files etc that may help.
Would love fault finding suggestions. David
Taunton
Sent from my MotoG3 using Tapatalk
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Proximity limit switch problems
By davrich in forum General ElectronicsReplies: 16Last Post: 12-03-2018, 01:58 PM -
Limit switch problem
By ECCO in forum General ElectronicsReplies: 7Last Post: 25-12-2015, 11:28 AM -
One limit switch per axis
By EddyCurrent in forum General ElectronicsReplies: 17Last Post: 30-09-2013, 11:38 AM -
Limit switch Cable ...
By Wobblybootie in forum General ElectronicsReplies: 3Last Post: 17-01-2011, 04:37 PM -
Limit switch's - best configuration?
By HiltonSteve in forum General ElectronicsReplies: 16Last Post: 13-08-2009, 01:26 PM
Bookmarks