Morning All,

I've been thinking as it will be a little bit longer till I can get my proper CNC built that I would pose the question about my little ROLAND CAMM-2 PNC-2300A as some of you may know it runs some Roland proprietary based software called Dr Engrave which to be honest I find a pain to get to to what I want it to do as you can't set anything properly (or I'm too dense to do it right)

I'm wondering as I've seen older post about people converting these to run better be it by replacing the EPROM or the controller board itself, if anyone could recommend any changes or mods I could look into for it?

I did debate a GRBL conversion and still have the board for that, but I stopped when I realised I may have issues controlling the spindle (correct me if I'm wrong).

But any help suggestions or help would be greatly appreciated.

Cheers

Rich